[v2] batman-adv: Add support for jumbo frames
Commit Message
Since batman-adv is not actually depending on hardware capabilities, it has
no limit on the MTU. Only the lower hard interfaces can limit it. In case
these have an high enough MTU or fragmentation is enabled, a higher MTU
than 1500 can be enabled.
Signed-off-by: Sven Eckelmann <sven@narfation.org>
---
There are from time to time discussions about supporting jumbo frames
with batman-adv. While the changes were known since a longe time [1],
reviews/tests [2] by the interested parties would be appreciated.
[1] https://www.open-mesh.org/issues/365
[2] https://www.kernel.org/doc/html/v6.4/process/submitting-patches.html#using-reported-by-tested-by-reviewed-by-suggested-by-and-fixes
---
Changes in v2:
- rebased on current main
- Link to v1: https://lore.kernel.org/r/20230727-jumbo-mtu-v1-0-036ce1a6e33c@narfation.org
---
net/batman-adv/hard-interface.c | 4 +---
net/batman-adv/main.h | 2 ++
net/batman-adv/soft-interface.c | 3 ++-
3 files changed, 5 insertions(+), 4 deletions(-)
---
base-commit: dfdce35d69c55b6b5d017a7e800e553089a26eb9
change-id: 20230727-jumbo-mtu-13d736059c84
Best regards,
@@ -618,10 +618,8 @@ int batadv_hardif_min_mtu(struct net_device *soft_iface)
/* the real soft-interface MTU is computed by removing the payload
* overhead from the maximum amount of bytes that was just computed.
- *
- * However batman-adv does not support MTUs bigger than ETH_DATA_LEN
*/
- return min_t(int, min_mtu - batadv_max_header_len(), ETH_DATA_LEN);
+ return min_t(int, min_mtu - batadv_max_header_len(), BATADV_MAX_MTU);
}
/**
@@ -22,6 +22,8 @@
#define BATADV_THROUGHPUT_MAX_VALUE 0xFFFFFFFF
#define BATADV_JITTER 20
+#define BATADV_MAX_MTU (ETH_MAX_MTU - batadv_max_header_len())
+
/* Time To Live of broadcast messages */
#define BATADV_TTL 50
@@ -790,7 +790,7 @@ static int batadv_softif_init_late(struct net_device *dev)
atomic_set(&bat_priv->log_level, 0);
#endif
atomic_set(&bat_priv->fragmentation, 1);
- atomic_set(&bat_priv->packet_size_max, ETH_DATA_LEN);
+ atomic_set(&bat_priv->packet_size_max, BATADV_MAX_MTU);
atomic_set(&bat_priv->bcast_queue_left, BATADV_BCAST_QUEUE_LEN);
atomic_set(&bat_priv->batman_queue_left, BATADV_BATMAN_QUEUE_LEN);
@@ -1047,6 +1047,7 @@ static void batadv_softif_init_early(struct net_device *dev)
* have not been initialized yet
*/
dev->mtu = ETH_DATA_LEN;
+ dev->max_mtu = BATADV_MAX_MTU;
/* generate random address */
eth_hw_addr_random(dev);